Conventional Pumping Systems
Features
- 5 performance ranges - 5, 7, 10, 18 & 25 GPM
- Ceramic shaft sleeve and rubber discharge bearing protect shaft and eliminate sand wear
- Intermediate bearing included in 5-25 GPM units greater than 24" in length and/or 2 hp and higher to provide improved shaft stability
- Thermoplastic impellers and stages for maximum efficiency.
- Thermoplastic and stainless steel models include built-in removable check valve system
- Urethane Eye & Hub Seals are remarkably resistant to abrasives, allowing sand and other abrasives to pass through each stage without wear or damage
- Powered by Franklin corrosion-resistant 4" submersible motors
- Maximum water temperature 120° F. Consult factory for further details
- Built in section screen on thermoplastic units, and removable suctin screen on stainless steel units prevents debris from clogging impellers and provides full flow performance